2017 Nissan Rogue Owner’s Manual — Battery replacement

CAUTION Be careful not to allow children to swallow the battery or removed parts.

NISSAN Jackknife key (if so equipped)

Replace the battery in the jackknife key as follows:

1. Hold jackknife key button side up. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.
2.  Remove old battery.
3.  Replace the battery with a now one.

Recommended battery: CR2032 or equivalent.

•  Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.
•  Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.

1.  Close lid securely as illustrated.

Operate the buttons to check the operation.

See a NISSAN dealer if you need assistance for replacement.

NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NISSAN Intelligent Key® (if so equipped)

Replace the battery in the Intelligent Key as follows:

1.  Remove the mechanical key from the Intelligent Key.
2. Insert a small screwdriver A into the slit B of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.
3.  Replace the battery with a new one.

Recommended battery: CR2025 or equivalent.

•  Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.
•  Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.
•  Make sure that the + side faces the bottom of the case.

1. Close the lid securely as illustrated C D .
2.  Operate the buttons to check the operation.

    

   See a NISSAN dealer if you need assistance for replacement.

FCC Notice:

For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.